Pneumatic Waste Oil Drainer Working Principle
The Pneumatic Waste Oil Drainer uses compressed air to drive a vacuum generator, quickly creating negative pressure within the oil tank (approximately 3 minutes), extracting waste oil from the vehicle’s engine, transmission, or cooling system into the approximately 20-gallon tank. Compared to traditional electric devices, the pneumatic system is more energy-efficient, effectively reducing energy consumption and meeting the low energy requirements for workshop environments.
AUTOOL OD710 Pneumatic Waste Oil Drainer Features
70L Large Capacity: The approximately 20-gallon tank has a large capacity to hold waste oil, reducing the need for frequent emptying and improving work efficiency.
1.5mm Thickened Body: Ensures leak-proof and spill-proof performance, providing peace of mind during operation.
Large 20L Oil Collection Pan: With a diameter of 41CM, it provides a spacious oil collection area for easy operation.
Adjustable Height: Featuring a height-adjustable lifting rod structure, with a maximum adjustable height of 1.5 meters, allowing for flexible height adjustment as needed.
Oil Level Viewing Window: Equipped with an oil level viewing window to monitor waste oil recovery, making it easy to determine when to empty the tank.
360° Swivel Casters: Fitted with 360° rotating casters for easy mobility, and the casters are equipped with a locking mechanism for enhanced load-bearing capacity.
Three-Year Warranty, Lifetime Maintenance: For damage caused by non-human factors, AUTOOL promises to resend parts for free within 3 years. If you have any problems, please contact us, and we will respond within 24 hours!
AUTOOL OD710 Pneumatic Waste Oil Drainer Operating Instructions
Installation
1. Secure the lifting rod and oil collection pan in a clockwise direction.
2. After installation, ensure the lifting rod is in a vertical position relative to the equipment.
3. To adjust the height of the lifting rod and oil collection pan, rotate the adjustment device counterclockwise to loosen, adjust the height, and then rotate clockwise to tighten.
Waste Oil Recovery
1. Lift the vehicle to the appropriate height using a lifting device.
2. In a safe working environment, move the equipment under the vehicle’s engine, positioning the oil collection pan to align with the engine’s drain plug.
3. Unscrew the vehicle’s engine oil drain plug.
4. The waste oil will drain from the engine into the oil collection pan and then into the storage tank.
Draining Waste Oil from the Storage Tank
1. Close the oil drain valve.
2. Close the air inlet valve of the oil tank.
3. Connect the air supply to the air inlet valve of the oil tank.
4. Open the air inlet valve of the oil tank to pressurize the tank. Once a certain pressure is reached, the check valve will automatically close. If the pressure inside the tank exceeds 1.0 bar, the safety valve will automatically release the pressure.
5. After 5 seconds, slowly open the oil drain valve to discharge the oil.
6. Once the oil has been drained, please disconnect the air supply.
Note
1. The air compressor must maintain a stable pressure of 7 bar.
2. Handle the extracted waste oil (40°C~80°C) with care to avoid burns.
3. When the waste oil temperature exceeds 60°C, it may cause damage to the equipment components!
4. Always turn off the engine switch during operation.
5. Avoid extracting gasoline, diesel, liquids containing methanol, ketones, or flammable substances.
6. After using the pneumatic waste oil drainer, please release the pressure inside the equipment, clean it properly, and ensure proper handling to prevent equipment damage and personal injury caused by improper operation.
